Paint & Powder Coating Pro

Precision Coatings

Trust In NikLyn Corp.

We understand first impressions last forever and when you work so hard at making a project successful and with your companies name on it, how it looks can make or break the impression that you leave behind. We treat every job with that knowledge.

High Quality Preparation

Your high quality finish begins with the substrate preparation. We take that seriously and offer a full spectrum of surface prep from abrasive blast cleaning, Iron Phosphate 3 & 5 stage process and Zinc Phosphate to a full line of conversion coatings.

Mailing Address

PO Box 268

Durham, CT 06422

Call us for proper shipping address and dock times

Shipping Address:

400 Sackett Point Rd.

North Haven, CT 06473

Office: 1-860-440-6244

Email: Info@NikLyncorp.com

Direct Sales: 203-996-4799

Quick Quote: sales@niklyncorp.com

Precision Powder Coating

North Eastern Faccility

Our North Eastern US Facility has over 120,000 square feet available to handle all size projects simultaneously.

WMBE. Owned

Here we have multiple automated lines for both powder coating and wet spray.

Large batch capacity able to fit a tractor trailer into one of our ovens.

5,000 square foot abrasive blasting room and a Large Lay-down area.

Why You Should Sandblast

Sandblasting or abrasive blasting is used for many reasons but most importantly, its used as a method of removing scale from steel. In any coating process the condition of your base is your weakest link. The best systems can fail if the substrate is not properly prepared.

Leaving rust on a substrate will only allow it to continue to form under your coating and at some point your coating will bubble up and pop as the oxidation pushes up on it. This spot failure will open the protective coating up to the elements and the rest of the surface will quickly begin to fail as moisture creeps in from the breaks.

This is why we always pre blast steel substrates when possible

Why You Should Sandblast Aluminum Parts

Yes, in many cases aluminum parts and assemblies should be cleaned and blasted to SSPC-SP7 finish. This accomplishes several things:

Cleans all surface grime
Breaks the glossy finish on most aluminums
Creates an anchoring profile
Smooth’s out welds, scratches and seams

The other uses and benefits from pre blasting a substrate are:

Smooth out welds and imperfections
Create a profile that the coatings can anchor into
On Galv to remove top layer of galv salt.
Clean off impurities from surfaces.
Remove embrittlement from laser cut edges.

Powder Coating